Pemanfaatan Limbah Stirofoam dan Karet Ban Sebagai Bahan Isolator Panas
DOI:
https://doi.org/10.30631/jssit.v1i1.89Keywords:
Styrofoam, Rubber tires, Thermal insulators, waste.Abstract
Rapid industrial development has caused an increase in the volume of waste such as styrofoam and rubber tires that are difficult to degrade naturally in nature. Utilization of waste as a thermal insulator is one of the best solutions and can overcome environmental problems. This material component has low thermal conductivity properties because of its ability to inhibit heat. The study aims to determine the effectiveness of Styrofoam and rubber tires at each additional thickness of the thermal insulator in retaining heat. This study uses an experimental method by observing the comparison of different material thickness variations, namely 0, 1, 3, 5 cm and measuring the temperature every 5 minute interval, for half an hour. The results of each measurement of the addition of styrofoam and rubber tires at a thickness of 5 cm produced the smallest heat transfer. The results of the average temperature comparison at a thickness of 5 cm of styrofoam were 69.28 ℃ while rubber tires were 67 ℃. This also shows the ability of styrofoam to retain heat better than rubber tires. The data from this study can be used as a reference in the management of styrofoam and rubber tire waste. This research innovation can contribute to the problem of waste that is difficult to degrade naturally.
References
DAFTAR PUSTAKA
E. Riatmojo, Y. Nurchasanah, M. Solikin, M. Ujianto, “Pengaruh Material Karet dari Limbah Ban Bekas Sebagai Serat pada Beton Terhadap Sifat Mekanis,” pp. 143–145, 2023.
A. Purbasari, T. A. C. Darmaji, C. N. Sary, H. Kusumayanti, “Pembuatan dan Karakterisasi Komposit dari Styrofoam Bekas dan Serat Ijuk Aren,” Metana, vol. 15, no. 2, pp. 65–70, 2019,
P. Muliyah, D. Aminatun, S. S. Nasution, T. Hastomo, S. S. W. Sitepu, “Exploring Learners’ Autonomy In Online language-learning in Stai Sufyan Tsauri Majenang,” Journal GEEJ, vol. 7, no. 2, 2020.
G. D. Gelyaman, R. E. Y. Adu, M. S. Batu, D. P. Benu, “Pelatihan Daur Ulang Sampah Plastik Menjadi Ecopaving bagi UKK Pemulung Desa Tublopo Kabupaten Timor Tengah Utara,” J. Pengabdi. Masy. MIPA dan Pendidik. MIPA, vol. 8, no. 1, pp. 56–62, 2024.
P. S. Dinanti, S. A. Siregar, and F. E. Putri, “Faktor-Faktor yang Berhubungan dengan Perilaku Penggunaan Styrofoam sebagai Kemasan Makanan pada UMKM Sektor Makanan di Kota Jambi Factors Associated with the Behavior of Using Styrofoam as Food Packaging in MSMEs in the Food Sector in Jambi City Makanann,” vol. 8, no. 1, pp. 38–47, 2024.
M. Liu, P. Zhu, X. Yan, H. Li, and X. Chen, “The Application of Solid Waste in Thermal Insulation Materials: A Review,” J Renew Mater, vol. 12, no. 2, pp. 329–347, 2024.
W. Himawari, I. M. Y. Negara, I. Gusti, and N. Satriyadi, “Analisis Pengaruh Kontaminan pada Isolator Polimer Terhadap Karakteristik Partial Discharge dengan Menggunakan Termal,” vol. 13, no. 2, 2024.
L. Saoqibillah and A. Malik, “Analisis Pengaruh Suhu Terhadap Nilai Konduktivitas pada Perpindahan Panas Secara Konduksi Menggunakan Virtual Lab Amrita,” Jurnal Penelitian dan Pembelajaran Fisika Indonesia, vol. 6, no. 1, 2024.
Vazri Muharom and Rifky, “Pengaruh Sifat Konduktivitas Termal Material Isolator (Kayu, Karet dan Stirofoam) Terhadap Perpindahan Panas dan Daya Keluaran Sistem Generator Thermoelectric,” METALIK : Jurnal Manufaktur, Energi, Material Teknik, vol. 1, no. 1, pp. 8–15, 2022.
C. T. Andersen, “Keefektifan Styrofoam Sebagai Material Kulit Bangunan Menginsulasi Panas,” Seminar Nasional AVoER 3, pp. 161–168, 2011, [Online]. Available: http://eprints.unsri.ac.id/124/1/Pages_from_Prosiding_Avoer_2011-19.pdf
A. Swilam, A. M. Tahwia, and O. Youssf, “Effect of Rubber Heat Treatment on Rubberized-Concrete Mechanical Performance,” Journal of Composites Science, vol. 6, no. 10, 2022.
Z. Pan, F. Liu, H. Li, X. Li, D. Wang, Z. Ling, H. Zhu, Y. Zhu, “Performance Evaluation of Thermal Insulation Rubberized Mortar Modified by Fly Ash and Glass Fiber,” Buildings, Vol. 14, No. 221, 2024.
D. Haryanto, A. Rosidi, M. Juarsa, S. Widodo, “Desain Isolator Termal pada Hotleg dan Coldleg FASSIP-02 Mod.01,” Rotasi, vol. 25, no. 2, pp. 70–76, 2023.
W. Widianto, Junaidi, and M. Taufiqurrahman, “Analisis Konduktivitas Termal Material Kaca Menggunakan Metode Lee’s Disc,” Junaidi & Taufiqurrahman, vol. 5, no. 1, pp. 73–77, 2023.
F. Maulida, F. Alatas, and D. Solehat, “Studi Literatur Miskonsepsi Pembelajaran Hukum I Termodinamika: Identifikasi Dan Solusi,” Seminar Nasioanl FITK UIN Jakarta, vol. 1, no. 1, pp. 170–180, 2024.
N. Setiawan, “Pengolahan dan Analisis Data,” Jurnal Pendidikan, vol. 1, no. 2, 2019.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 JSSIT: Jurnal Sains dan Sains Terapan
This work is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License.
